Manual

PW-TR100 : POWER UNIT

MENU MENU

MODE-1

MODE-2

Configuring main unit

When the MENU button is pressed with the Measuring screen displayed, the menu screen appears. The

menu includes a total of 17 screens as shown in the figure below: the main unit settings can be checked or

changed using these screens.

The basic information on how to use the menu screen is as follows:

1. When the Measuring screen is displayed, press the MENU button to switch to “Wheel circumference”

of the menu screen.

2. Press the MODE-1 or MODE-2 button until desired menu screen appears.

3. Press the START/STOP/ENTER button to change the settings.

NOTE: For information on how to change various settings, refer to the relevant page as shown below.

4. When the setting change is completed, press the START/STOP/ENTER button to confirm the setting

and return to the menu screen.

NOTE: Make sure to press the START/STOP/ENTER button each time the setting is changed.

Pressing the MENU button cancels the setting.

5. Press the MENU button to return to the Measuring screen.

NOTE: After one minute idle, menu screen will return to the Measuring screen.

OFF-Power: *1 Press the MENU button with the Measuring screen displayed

to bring up the “Wheel selection” menu screen.

*2 This menu is displayed when the Power Select and Data Stor-

age options are set to ON.

Power select Wheel selection Tire circumference input Auto-mode Sound

Date

See page 36 See page 36 See page 37 See page 37 See page 38

Setting clock

Manual odometer input

Speed unit

Defining remote

button setting

Cadence zoneHeart rate zoneHeart rate sensor IDData file

See page 39

See page 40

See page 40See page 40See page 41See page 43See page 46See page 47

Data storage

See page 49

PC Link

See page 50

Torque *2

Menu screens at

a glance

Main display

See page 51