User Manual

ENG-29

ENG

1. Press the MENU button on the measurement screen to

switch to the menu top screen.

Switch to the SEnSOR-ID screen using the M1/+ and M2/-

buttons, and confirm with the SSE button.

Menu top:

Changing the menu:

M1/+

M2/-

Confirm:

SSE

2. Select the sensor ID to be checked.

Select “SP1 (speed sensor 1)” and “SP2 (speed sensor 2)”

using the M1/+ and M2/- buttons.

Selecting the sensor:

M1/+

M2/-

3. Check whether the speed/cadence is mounted properly.

4. Press the SSE button to start searching the ID.

When the speed (cadence) is displayed as “ID-OK” on the

screen by spinning the rear wheel or crank, synchronizing is

completed.

Start searching:

SSE

5. Pressing the MENU button returns to the menu top screen

(SEnSOR-ID screen), and confirm the change.

Pressing it again returns to the measurement screen.

To the menu top/measurement screen:

* This unit enters the search mode for 5 minutes after starting the ID synch.

While “ID-SKIP” is indicated, press the SSE button in the search mode to cancel

the ID synch, and “ID-SKIP” is displayed. Unless a sensor signal is received in 5

minutes, “ID-ERROR” is displayed.

When “ID-SKIP” or “ID-ERROR” is displayed, the ID has not been synchronized

properly. In such a case, the sensor ID retains the previous ID setup. Check

whether the speed/cadence is mounted properly, is mounted properly, before

you check the ID again.

* SP2 is used when a computer is commonly used for second bicycles. By synchro-

nizing the ID of the second bicycle equipped with a second speed/cadence sensor

and the computer with SP2, re-synchronizing the ID is not required every time you

move the computer between first and the second bike.

(or)

(Back)