User Manual

ENG-38
Trouble shooting
If a malfunction occurs, check the following before contacting CatEye or your retailer for
repair or service.
Trouble on display
Trouble Check Items Remedy
Display motion be-
comes slower.
Is the surrounding tempera-
ture low (below zero degree
Celsius or 32 degrees Fahr-
enheit)?
Temperatures below freezing may re-
sult in slower screen response. Data
is not affected.
Flashes on the
screen.
The remaining battery ca-
pacity for the computer is
low.
Replace it with a new battery
(CR2032) immediately.
After replacement, be sure to
perform the restarting operation
(page 11).
No displays appear. Is the battery for the com-
puter empty?
Replace it with a new battery
(CR2032).
After replacement, be sure to
perform the restarting operation
(page 11).
Meaningless display
appears.
Perform the restarting operation
(page 11).
Cannot measure the
trip speed (cadence)
Have you checked the sensor ID?
Is the computer ID Synch'ed
with somebody else's sensor?
Is the Speed and Cadence
sensor icon on , ?
Check whether the distance
between the speed (ca-
dence) sensor and the mag-
net is too large.
Is the sensor zone of the
speed (cadence) sensor off
the center of the magnet?
Has the power-saving func-
tion been activated, showing
only date/clock on the
screen?
Is the battery for the speed
sensor empty?
Check the speed sensor ID (page 29)
for SP1 (speed sensor 1) or SP2
(speed sensor 2).
If the Speed and Cadence sensor
icon is off
, , the computer can-
not receive data. Press the M1/+ or
M2/- button once to turn on the icon.
Adjust the position of the speed (ca-
dence) sensor and that of the mag-
net correctly. (See “How to install the
unit on your bicycle” on page 6.)
Press any button on the computer
to cancel the power-saving function.
Replace it with a new battery
(CR2032).
After replacement, be sure to press
the RESET button on the speed
sensor.