User Manual

ENG-30

1. Press the MENU button on the measurement screen to

switch to the menu top screen.

Switch to the SEnSOR-ID screen using the M1/+ and M2/-

buttons, and confirm with the SSE button.

Menu top:

Changing the menu:

M1/+

M2/-

Confirm:

SSE

2. Select the sensor ID to be checked.

Select it from “Hr (heart rate sensor)”, “SP1 (speed sensor 1)”,

and “SP2 (speed sensor 2)” using the M1/+ and M2/- buttons.

Selecting the sensor:

M1/+

M2/-

3. Check whether the heart rate sensor is worn properly when

you selected “Hr”, or whether the speed sensor is mounted

properly when you selected “SP1” or “SP2”.

4. Press the SSE button to start searching the ID.

Spin the rear wheel or crank when you selected “SP1” or

“SP2”.

When the heart rate or speed (cadence) is displayed with

“ID-OK” on the screen, synchronization is completed.

Start searching:

SSE

5. Pressing the MENU button returns to the menu top screen

(SEnSOR-ID screen), and confirm the change(s).

Pressing it again returns to the measurement screen.

To the menu top/measurement screen:

* This unit enters the search mode for 5 minutes after starting the ID synch.

While “ID-SKIP” is indicated, press the SSE button in the search mode to cancel

the ID synch, and “ID-SKIP” is displayed. Unless a sensor signal is received in 5

minutes, “ID-ERROR” is displayed.

When “ID-SKIP” or “ID-ERROR” is displayed, the ID has not been synchronized

properly. In such a case, the sensor ID retains the previous ID setup.

Be sure to check the sensor/mounting condition before you check the ID again.

* SP2 is used when a computer is commonly used for second bicycles. By synchro-

nizing the ID of the second bicycle equipped with a second speed/cadence sensor

and the computer with SP2, re-synchronizing and the computer with SP2, syn-

chronizing the ID is not required every time you move the computer between first

bike to the second bike.

(or)

(Back)