User Manual

ENG-14

3. Verify that the speed/cadence sensor is mounted properly to

the bicycle.

4. Press the SSE button to start searching the speed sensor ID.

When the speed (cadence) is displayed as “ID-OK” on the

screen by spinning the rear wheel or crank, searching is

completed.

Start searching:

SSE

5. Press the MENU button to proceed to “Selecting speed unit”

below.

To “Selecting speed unit”:

* This unit enters the search mode for 5 minutes after starting the ID check.

Press the SSE button during the search mode, then “ID-SKIP” is indicated and it

proceeds to “Selecting speed unit” screen below. Or, unless a sensor signal is

received in 5 minutes, “ID-ERROR” is indicated and it proceeds to “Selecting

speed unit” screen below.

When “ID-SKIP” or “ID-ERROR” is indicated, this unit is not ready for

measurement because the sensor ID has not been registered even though the

set-up is completed. Be sure to check the sensor ID from the menu screen

“Searching the sensor ID” (page 29).

5. Selecting speed unit

Select the speed unit from “km” and “mile”.

1. Select the speed unit.

C mile:

M1/+

M2/-

2. After selecting, press the MENU button. The measurement

screen appears and the computer set-up is completed.

(or)

(Back)