Operation Manual

9
MOUNTINGTHELIGHTUNITONAHELMET 
(3/3)
6
Extension cable
Ring
Position alignment mark
Plug
Connect the plug so that the directions of the arrow and the
mark match.
To remove the plug, hold the ring, and then pull out the plug.
Knob
Unlock
Lock
Set the knob of the control unit to the “Unlock” position, align
the battery unit with the position alignment mark, and then slide
the battery unit into place.
CAUTION!: Afteryouconnectthebatteryunit,besureto
settheknobbacktothe“Lock”positionto
lockthebatteryunitinplace.
To remove the battery unit, set the knob to the “Unlock” posi-
tion, and then pull out the battery unit.
Battery unit
Control unit
7
Slide
8
Check that the light turns on when you press the remote control
switch near the control unit.
CAUTION!: Donotlookdirectlyatthelightwhenitison.
Insulation
sheet
Rubber band
(WSW-001)