Operation Manual

Switching to Sensor Direct Mode

Pairing a smart computer with a sensor

• Pairing (sensor ID synchronization) must be performed in order to use a sensor.

• Do not pair sensors at a race venue or in similar locations where there are a lot of other

users. Doing so may cause the smart computer to be paired with another device.

• Pair all sensors that you intend to use.

Currently, only Bluetooth sensors that comply with Bluetooth Low Energy (BLE) proﬁles can

be used in Sensor Direct Mode.

Important

Pair a sensor that you want to use with smart computer.

1. From the measurement screen, press OPTION for 2 seconds to switch to

the sensor pairing screen.

* When the sensor pairing screen is left on for 1 minute, the smart computer returns to the

measurement screen.

2. Press SS/LAP to start pairing.

3. Activate the sensor that you want to pair.

Activating the sensor

The name of the synchronized sensor is displayed and pairing is completed.

• SP : Speed sensor

• ISC : Speed/cadence sensor

• CD : Cadence sensor

(2 seconds)

Sensor pairing

screen

Measurement

screen

Sensor

activated

Synchronizatio

n complete

Ready for

synchronization