Operation Manual

41
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
Troubleshooting
The following troubles are not due to failure.
See also “FAQ” in CATEYE Atlas™ (web) (http://www.cateyeatlas.com/qa/).
Troubles related to the computer
Trouble Check Items Remedy
When the power is
turned on,
(bat-
tery icon) flashes, and
then no display ap-
pears.
–
Remaining battery capacity is
nearly zero. Charge the computer
according to the procedure in “How
to charge” (page 7).
The power is turned off
while riding.
–
The power is automatically turned
off in 10 minutes if no GPS signal
or speed signal is received. (Auto
power off)
No display appears
when pressing and
holding the
button
for 2 seconds.
Is the battery for the com-
puter empty?
Charge the computer according to
the procedure in “How to charge”
(page 7).
Incorrect data appear.
–
Follow the procedure in “When the
operation is unstable” (page 40).
Measurement cannot
be performed.
(When using an ANT+
sensor capable of
speed measurement)
S or C does not flash
Have you paired the com-
puter with the sensor?
Perform pairing (page 36).
Is the condition for mount-
ing the sensor cleared?
Mount the sensor correctly by
referring to the instruction manual
supplied with your sensor.
Is the battery for the sensor
used up?
Replace with new batteries.
STOP is displayed
–
Measurement is paused.
Press the
button to start mea-
surement.
For details, see “Starting/Stopping
measurement” (page 16).
Trouble Check Items Remedy
Measurement cannot
be performed.
(When not using an
ANT+ sensor capable of
speed measurement)
flashes
Is it immediately after
turning on the power?
It may take about 2 to 3 minutes to
acquire the positional information
after receiving GPS signal.
Is the location or weather
suitable for receiving the
GPS signal?
GPS signal may not be received,
thus the unit may stop measure-
ment or may not display appropri-
ate measurements in the following
locations or environments.
• In a tunnel, underground and
building, between high-rise build-
ings, under an elevated structure
and arcade, etc.
• In bad weather (snow, rain, etc.)
• Near a high-voltage line or a
mobile telephone relay station.
• The computer display does not
face upward.
Is the unit installed so that
the computer display (an-
tenna) faces to the sky?
To receive GPS signal effectively,
install the unit so that the computer
display faces to the sky.
STOP is displayed
–
Measurement is paused.
Press the
button to start mea-
surement.
For details, see “Starting/Stopping
measurement” (page 16).