Operation Manual

36
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Others
Changing the
computer
configuration
MODE
MODE
MODE
Selecting the sensor
Select the sensor to be paired.
MODE
SP (Speed sensor)
ISC * (Speed/cadence sensor)
CD (Cadence sensor)
HR (Heart rate sensor)
PW (Power sensor)
* When using the CATEYE speed/cadence sen-
sor (ISC-11), select [ ISC ] to perform paring.
From “Setting the tire circumference” (page 35)
Pairing the sensor
Selecting the sensor number
2 sensor IDs per sensor type can be regis-
tered into the computer.
MODE
1 (1 sensor)
↔
2 (2 sensor)
* The computer recognizes two bicycles au-
tomatically by pairing the sensor installed
to the second bicycle while selecting 2
(second bicycle).
* The next step differs depending on wheth-
er automatic search or manual ID number
entry is selected. Go to the appropriate
step according to your selection.
Continue
(page 37)
To add or reset the ANT+ sensor, perform pairing in the following procedure.
This unit has 2 different methods for pairing.
How to search
the sensor ID
Description
Automatic
search
The computer completes pairing by receiving the signal sent from the
sensor.
* Generally, use this method for pairing.
Manual ID
number entry
When the sensor ID number is known, you can perform pairing by
entering the number.
* Use this method for pairing, when there are two or more ANT+ sen-
sors, such as at a race site, and automatic search cannot be done.
(Press
& hold)
To “Night-time setting” (page 38)
(Press & hold)
Changing
the settings
This setting is required when you have an ANT+ sensor.
(searching the sensor ID)