Operation Manual

26
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Changing the
computer
configuration
Others
Uploading the
measurement data
Trip data
Data contained in the trip data
Date and clock (date/time when the measurement started)
Elapsed time
Data recorded at the record interval specified
• Location information
• Trip distance
• Altitude
• Current speed
• Cadence (*1)
• Heart rate (*1)
• Power (*1)
*1 : These are measured when using an ANT+ compatible sensor.
Record interval and capacity limit
This unit records data at the specified interval. The record interval can be selected from 1, 2
or 5 seconds according to your use (Default: 1 second).
The maximum recording time and the maximum time for one trip depend on the selected
record interval as follows.
Record interval
Maximum recording time
(total time of all trip data)
Maximum time for
one trip
Maximum number
of trips
1 second 35 hours 12 hours
250 trips2 seconds 70 hours 24 hours
5 seconds 175 hours 60 hours
* The recording time and number of trips above are for reference only. These may be differ-
ent according to the operating environment.
* For information on record interval settings, see “Setting the record interval” (when using
CATEYE Sync™: page 30, when using the computer alone: page 38).
* When exceeding any of the conditions above, “ MEM FULL ” appears flashing on the screen,
and no new data can be recorded. Transfer the trip data to CATEYE Sync™ to secure the stor-
age volume of the computer. Only when exceeding the maximum time for one trip, the reset-
ting operation (page 18) allows you to start the measurement as another trip.