Operation Manual

22
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Changing the
computer
configuration
Others
Uploading the
measurement data
The trip data generated by the resetting operation can be uploaded to the special website
CATEYE Atlas™ or other services (STRAVA™ and others) in the following procedure.
* It is recommended to download trip data to your PC frequently. If too much data is ac-
cumulated, it may take a long time to download or cause a download error.
Uploading trip data
Save the trip data in the computer to your PC, and upload desired trip data to CATEYE Atlas™,
STRAVA™, or TrainingPeaks™.
* The trip data without the resetting operation cannot be recognized with CATEYE Sync™.
Perform the resetting operation of the computer before setting to the cradle.
1
Set the computer to the cradle
Caution:
Do not set wet computer to the cradle, for example
after ride in the rain. It may cause short circuit and
damage the computer or the data.
2
Insert the USB plug into your PC
Only (battery icon) is displayed on the screen.
3
Start CATEYE Sync™
Double-click on the shortcut [CATEYE Sync™] to start CATEYE Sync™.
Click the button, then a browser will open and a
video will be played back.
Watch video
(YouTube)
Uploading the measurement data (trip data)
Cradle
Computer
4
Check that “STEALTH” is selected under Device, and click [Download
All Activities & View Data List]
The trip data is downloaded from the computer to your PC, and the data list screen
appears.
* Trip data successfully downloaded to your PC is deleted from the computer.
* Data under measurement that has not been reset cannot be read.
Device