Operation Manual

5 mm
CC-ED400 ENG 2
How to install the unit on your bicycle
WhenattachingtheFlexTight™brackettothestem
1
Attach the bracket to the stem or handlebar
2
Install the sensor and magnet
3
Route the wire
TheFlexTight™bracketcanbeattachedtoeitherthestemorthehandlebar,dependingonhowthebrackettsintothe
bracketband.
Remove/Install
the computer
Sensor
Nylonties
(x7)
Magnet
Nylonties
Nylonties
Nylonties
NylontiesHandlebar
Click
Whilesupportingitbyhand,
Pushitoutasiflifting
thefrontup
Stem
Bracket
Wire
Double-sidedtape
Spiraltube
Spiraltube
Bracket
Bracket
Bracket
Bracket
Double-sidedtape
Double-sidedtape
Pull
securely
Magnet
Spoke
Magnet
Magnet
SENSOR ZONE
Sensor
Sensor
Magnet
Sensor
Sensor
Nylonties
Nylonties
SENSOR
ZONE
Tothe
SENSOR ZONE
WhenattachingtheFlexTight™brackettothehandlebar
Install the sensor and magnet
Themagnetpassesthroughthe
sensorzone.
Theclearancebetweenthesen-
sorandmagnetis5mmorless.
Securethecordontheforkwiththenylontiesandleadtothehandle
baralongtheoutercableofthebicyclebymeansofthespiraltube.
Caution:
Adjust the wire length so that it may not be pulled when the han-
dle is operated.
*Themagnetmaybein-
stalledanywhereonthe
spokeiftheaboveinstal-
lationconditionsaresatis-
ed.
1
2
Pullsecurely
Pullsecurely
OK
NO!
Cut
Cut
Cut