Operation Manual
- 5 -
III. User Manual
1). Please put suitable cookware onto the plate of induction cooker, and connect the plug to suitable
socket. After connected, the light of Power will shine, indicating that the power is connected
normally.
2). Pressing , the light of Heating will shine, indicating that the induction cooker is entering the
state of heating; the default power of heating is 6. Adjust the power rate from 1-15 by turning the
knob.
3). By pressing the HEAT/KEEP button can you change between temperature and capacity. The
concerned light will burn. You can adjust the temperature from 60°C up to 220°C by turning
the knob. The maximum temperature of the glass plate is 220°C, by overheating the induction
cooker will shut off automatically.
4). Adjust the time from 0 minute to 120 minutes by “+” or “
▬
” at the state of Time.
5). When pressing during the working State, the induction cooker will stop working immediately.
After stopping working, the fan will cool down the induction cooker for one minute, and then will
be off.
6). The induction cooker will shut off automatically if there is no any operation within 2 hours.
IV. Usable and Non-usable Utensils
1). Usable Pans:
Steel or cast iron, enameled iron, stainless steel, at-bottom pans / pots with diameter
from 12 to 26cm.
Enameled Iron Iron or Enameled Castiron Pan Iron Pot Deep-Fry Pan Stainless Steel Pot Iron Plate
Pot Iron Pot
2). Non-usable Pans:
Heat-resistant glass, ceramic container, copper, aluminum pans/pots.
Rounded-bottom pans/pots with bottom measuring less than 12cm.
Rounded Bottom Aluminum Bottom Measuring Pot with Stands Ceramic Pot Heat-Resistant
Pot Copper Pot Less than 12cm Glass Pot
V. Cleaning
1). Unplug and wait until the cooker is cooled down completely.
Clean the cooker after using each time.
2). If the pots/pans are used without being cleaned, discoloration or stains may occur.
3). Do not use gas, thinner, scrubbing brush or polishing powder to clean the induction cooker.
4). Wipe using dish washing agent and damp cloth.
5). Use a vacuum cleaner to suck out dirt from the air intake and exhaust vent.
6). Never run water over the machine (water getting inside may cause malfunction).
ENGLISH