User`s manual

THIS MODEL PHONE MEETS THE GOVERNMENT

’

REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission

limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S.

Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for

the general population. The guidelines are based on standards that were developed by independent scienti¿c

organizations through periodic and thorough evaluation of scienti¿c studies. The standards include a substantial

safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for

wireless mobile phones employs a unit of measurement known as the Speci¿c Absorption Rate, or SAR. The SAR

limit set by the FCC is 1.6 W/kg. *

Tests for SAR are conducted with the phone transmitting at its highest certi¿ed power level in all tested frequency

bands. Although the SAR is determined at the highest certi¿ed power level, the actual SAR level of the phone while

operating can be well below the maximum value. This is because the phone is designed to operate at multiple

power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless

base station antenna, the lower the power output. Before a phone model is available for sale to the public, it

must be tested and certi¿ed to the FCC that it does not exceed the limit established by the government adopted

requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the

body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at

the ear is 0.544 W/Kg and when worn on the body , as described in this user guide, is 0.136 W/Kg. (Body-worn

measurements differ among phone models, depending upon available accessories and FCC requirements). While

there may be differences between the SAR levels of various phones and at various positions, they all meet the

government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone

with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on

this model phone is on ¿le with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/

fccid after searching on FCC ID: ZP4CW30.

Additional information on Speci¿c Absorption Rates (SAR) can be found on the Cellular Telecommunications

Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and Canada, the SAR

limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard

incorporates a sub-stantial margin of safety to give additional protection for the public and to account for any

variations in measurements.

SAR INFORMATION