User`s manual

89
 In order to strengthen security, the network bridge (especially Remote NDIS adapter Connection Bridge)
of a computer must be deactivated before connecting the device to a computer passing through the
Internet or other networks. For further information on the network bridge, see Windows online help of the
computer.
ActiveSync using serial port services
As is the case with a wired serial cable connection, ActiveSync also uses a wireless Bluetooth serial port connection.
Therefore, an application required for connecting to the correct serial port must be con¿gured.
Con¿gure Bluetooth features of the device prior to establish a Bluetooth ActiveSync connection.
The following instructions correspond to the computers running Windows XP higher than SP2.
How to con¿gure Bluetooth ActiveSync
1
2
3
4
5
6
7
9
8
Activate Bluetooth on both devices and turn on detection mode. Check the distance between two devices is
within 10 m (30 ft).
Double click Start > Settings > Con¿guration Panel > Bluetooth device.
Check Search for a Bluetooth Device checkbox on Option tab and Allow a New Bluetooth Device to Connect to
This Computer checkbox.
Choose Receive (start connection from the device) options after clicking Add on COM port tab and click OK.
Click OK after checking the added COM port.
Click Start > ActiveSync.
Click File > Connection Settings
Allow one connection out of the followings: Press Start > ActiveSync after selecting a COM port whose number
was checked in the previous step from the drop-down menu.
To disengage the ActiveSync connection, select ActiveSync icon on the Home Screen and click Disconnect.
Choose a connection via Menu > Bluetooth.
Synchronization will automatically initiate and ActiveSync icon will appear at the bottom of the right corner on the
Home Screen. If certi¿cation is required, a password window will appear, then enter a password (PIN code) and
press Enter and repeat this procedure on the other device. The use of password is recommended for enhanced
security and the digit of a password should be between 1 to 16 characters combined with English letters and
numbers. If you are not going to use a password, just click Next.
 This process alone will not create a partnership. To make a partnership again, the application must run
Microsoft Bluetooth Stack by opening the selected COM port.
$BVUJPO
$BVUJPO