❡ㅷ霹僈⛼
Put 4 AA batteries into the battery compartment, As a backup power source *Please make sure there is no grain in the barrel before installing the battery *The barrel can be installed upside down Press the USB cable flatly into the bottom power cord slot Attention： This is an emergency power supply for power failure.
Open the cover and add pet food Place desiccant evenly into the box behind the top To download the app, press Prompt to add device, set mobile Feeding plan Press the manual feed button three times,One portion of grain can be produced (about 10g-15g) %QFU 4NBSU
(1) IOS users can search for "Smart Life" in the APP Store to download. (2) Android users can search for "Google Play" APP in the browser, search for "Dpet smart" in "Google Play" and download and register. *The equipment needs to be connected to the power supply first, and then the distribution network operation.
3. Make sure that the encryption method in the wireless settings of the router is WPA2-PSK, the authentication type is AES, or both are set to automatic. The wireless mode cannot be 11n only; 4. If the router enables wireless MAC address filtering, you can try to remove the device from the router's MAC filtering list to ensure that the router does not prohibit the device from connecting to the Internet, or turn off MAC address filtering; 5.Make sure that the router has enabled the DHCP service.
1. The wifi password is incorrectly entered (the small eyes that can open the input page) 2. Connected to a 5G network (generally a router will release 2 frequency bands, 2.4G and 5G, check whether the wifi name has the word 5G, if it is connected to 2.4G, you need to contact the router manufacturer to turn off the 5G signal) 3.
¢ No need to re-operate the distribution network, the module will automatically work It is recommended to take out the turntable and wipe it with a wet wipe When successfully connected, find and click the icon in the on the device control page, click Sharing Device and input the phone number to send device s
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
¤ ¥ ¤ ¢
