Manual

8
GETTING STARTED
INSTALLING SIM CARD AND MEMORY CARDS
1. Place your device on a fl at clean surface with the display facing up.
2. Use your fi ngertip to pull out the SIM/SD door and the SIM/SD tray.
3. Place the SIM card in the SIM tray with the gold pins of the SIM facing down, towards the back of the phone.
4. If you would like to use a microSD card, place this on the microSD tray with the gold pins of the card facing down.
5. Carefully insert the tray back into the SIM card slot and close the door.
NOTE: A SATELLITE SIM CARD IS PRE-INSTALLED IN THE FACTORY. YOU CANNOT USE SATELLITE FUNCTIONALITY WITHOUT
THIS SIM CARD. AFTER FITTING YOUR SIM CARD PLEASE PUSH THE SIM/SD DOOR BACK IN UNTIL IT IS CLOSED SECURELY
TO MAINTAIN THE WATER RESISTANCE OF YOUR PHONE.
CHARGING THE BATTERY
1. The Cat S75 battery cannot be removed. To charge the battery place the USB cable in the USB port as shown below:
2. Connect the USB power cable to a charging power adaptor and insert the adapter to the electrical mains.
IMPORTANT INFORMATION REGARDING FUTURE USE OF THE BATTERY
When the battery power level is low, the device displays a prompt. When the battery level power is almost exhausted, your phone
will power off automatically. The time required to charge the battery depends on its age and the environmental temperature.
If the battery is completely exhausted, your device may not power on immediately after charging starts. Allow the battery to
charge for a few minutes before attempting to turn it on. The on-screen charge animation may not be displayed during this
period.
SIM1
SIM2/SAT
SD
SIM1
SIM2/SAT/SD