Instructions

24
ADDING ADDITIONAL MEASUREMENTS:
• You can add lines, triangular or square area measurements within an image.
• This can be done immediately after the image is captured, or with an image saved in the Measure gallery.
NOTE:
Additional measurements can only be accurately added to parts of an image that show objects that are the same distance
away as the surface on which the laser dot is shown.
For example, if a picture shows a box in front of a wall, and the laser dot is on the box, additional measurements can only be
made on the surface of the box. Attempting to measure the wall would give incorrect results.
TAKING A LENGTH MEASUREMENT
1. Follow steps 1-5 for Taking a distance measurement.
2. Tap the Line icon .
3. Tap and hold one end of the line. Drag to the edge of the space you wish to measure.
4. Tap and hold the other end of the line and place at other edge of the space.
5. You can ne-tune the end point locations using the pop-up window.
6. The length of the line will now be shown.
TAKING AN AREA MEASUREMENT
1. Follow steps 1-5 for Taking a distance measurement
2. Tap the Triangle or Area icon .
3. Tap and hold and to move each of the corners in turn until you have covered the area you wish to measure.
4. Place each point of the green area box over the area you wish to measure.
5. The length of each line will be shown with the area measurement in the centre.
Tips:
• To remove a line, triangle or area measurement on an image that has not been saved, tap and hold, then select DELETE.
• Change the unit of measurement in the Settings menu.