User Manual

C49R Model 641748
8
Post Operation
Perform the below steps after operating the machine and before storing:
1. Release the accelerator pedal, turn off the brush, dust collection and spray buttons. Wait for the
machine motors to stop.
2. Rotate the roller brush handle (on the right side) counterclockwise to lift the roller brush. Rotate
the side brush handle (on the left side) clockwise to lift the side brush.
3. Move the machine to the designated area for dumping
garbage. Open the dust box latch and remove the box. Empty the
garbage. Then mount the dust box back and buckle the latch.
4. Move the machine to the designated parking area, release the
accelerator pedal, and push the directional switch to the
central/neutral gear. Wait for the machine to stop completely.
Turn the key switch to the "OFF" position to power down the
machine and then pull the key out from the instrument panel.
CAUTION
Do not leave the machine unattended with the switch key in the machine. In addition, do not park
the machine in an open area or on an uneven floor.
MACHINE STORAGE
Store the machine indoor in a dry location with the squeegee and pad/driver raised off the floor.
Turn off the brush and vacuum using the touch screen before shutting off the machine.
Always drain the solution and recovery tank fully before storing, especially when storing in a cold
location.
MAINTENANCE
WARNING
Before performing any maintenance on the machine, make sure that the power is turned off or the
batteries are disconnected. Repairs are to be completed by authorized service centers only. Any
repairs by unauthorized persons will void warranty.
Cleaning Filter Cartridge
1. After each operation, press and hold the Dust Shaker Switch for 10 seconds to
remove dust from the cartridge;