Specifications

SEBU7858-03 105
Maintenance Section
Auger Drive Gear Oil - Change
g00944004
Illustration 111
Note: Breather (1) is located on the gearbox for
the auger. Do not operate the machine without the
breather.
5. Clean the area around the breather.
6. Remove the breather.
7. Wash the breather in clean, nonflammable
solvent. Allow the breather to dry.
8. Install the breather.
i02457747
Auge r Drive Gear Oil - Change
SMCS Code: 5326-044-OC
S/N: DBZ1-Up
NOTICE
Care
must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
coll
ect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, “Caterpillar
Dealer Service Tool Catalog” for tools and supplies
sui
table to collect and contain fluids on Caterpillar
products.
Di
spose of all fluids according to local regulations and
mandates.
1. Park the machine on level ground. Run the engine
a
tlowidle.
2. Move the transmission control to the NEUTRAL
p
osition. Engage the parking brake.
3. Lower the bowl t
o the ground. Open the apron.
Lock the apron in the RAISED position. Refer to
Operation and Maintenance Manual, “Blocking the
Bowl and Apron
” for further information.
4. Stop the engine.
g00944007
Illustration 112
Note: The gearbox is located at the top of the auger.
5. Clean the area around drain plug (3). Clean the
area around oil filler plug (1).
6. Remove the drain plug. Allow the oil to drain into a
suitable container .
7. Clean the drain plug. Install the drain plug.
8. Remove oil filler plug (1). Fill the gearbox with the
proper amount of oil. The oil should be visible in
sight gauge (2).
Refer to Operation and Maintenance Manual,
“Lubricant Viscosities” for further information.
Refer to Operation and Maintenance Manual,
“Capacities (Refill)” for further information.
9. Clean the oil filler plug. Install the oil filler plug.