Specifications

104 SEBU7858-03
Maintenance Section
Auger Bearing Oil Level - Check
13. Install cover (
2) and screws (1).
i02457745
Auge r Bearing Oil Level -
Check
SMCS Code: 6282-535-BD
S/N: DBZ1-Up
NOTICE
Care must b
e taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect t
he fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, “Caterpillar
Dealer Service Tool Catalog” for tools and supplies
suitabl
e to collect and contain fluids on Caterpillar
products.
Dispose
of all fluids according to local regulations and
mandates.
1. Park the machine on level ground. Run the engine
at low i
dle.
2. Move the transmission control to the NEUTRAL
posit
ion. Engage the parking brake.
3. Lower the bowl to the ground. Open the apron.
Lock
the apron in the RAISED position. Refer to
Operation and Maintenance Manual, “Blocking the
Bowl and Apron” for further information.
4. Stop the engine.
g00943824
Illustration 109
Note: The bearing is located on the lower end of the
auger.
5. Clean the area around screws (1) and cover (2).
6. Remov e screws (
1) and cover (2).
g00943828
Illustration 110
7. Clean the area around oil level/fill plug (3).
8. Remove oil level/fill plug (3). Maintain the oil level
to the bottom of the opening for the oil level/fill
plug.
9. If oil is needed, clean the area around vent plug
(4). Remove vent plug (4). Add oil through the
opening for the oil level/fill plug.
Refer to Operation and Maintenance Manual,
“Lubricant Viscosities” for further information.
Refer to Operation and Maintenance Manual,
“Capacities (Refill)” for further information.
10. Clean the oil level/fill plug. Install the oil level/fill
plug.
11. Clean the vent plug. Install the vent plug.
12. Install cover (2) a nd screws (1).
i02457746
Aug
er Drive G ear Breather -
Clean
SMC
S Code: 5326-070-BRE
S/N: DBZ1-Up
1. Park the machine on level ground. Run the engine
at low idle.
2. Move the transmission control to the NEUTRAL
position. Engage the parking brake.
3. Lower the bowl to the ground.
4
.
S
top the engine.