Specifications

SEBU7858-03 169
Maintenance Section
Transmission Oil Filter and Magnetic Screen - Replace/Clean
Procedure for the Scraper
g00944478
Illustration 237
Transmission oil filter housing (8) is located on the
left side of the transmission case at the left rear of
the scraper engine. Magnetic screen (12) is located
on the side of the transmission oil reservoir for
the scraper toward the front of the machine. The
transmission oil reservoir is located on the right side
of the scraper engine.
Transmission Oil Fi lter
1. Park the machine on level ground. Engage the
parking brake.
2. Lower the bowl to the ground. Stop the engine.
3. Clean transmission oil filter housing (8). Clean the
area around the cover for the transmission oil filter
housing. Clean the area around drain plug (9).
4. Remove the drain plug. Allow the oil to drain into a
suitable container.
5. Remove bolts (7
) from the transmission oil filter
housing. Remove the cover from the transmission
oil filter housing.
6. Remove the used filter element and discard the
used filter element according to local regulations.
7. Clean the inside of the transmission oil filter
housing with a clean towel.
8. Insert a new filter element into the transmission oil
filter housing.
9. Inspect the seal for the transmission oil filter
housing. Replace the seal if the seal is damaged.
10. Install the cover on the transmission oil filter
housing. Install the bolts on the transmission oil
filter hous
ing.
11. Clean the drain plug. Install the drain plug in the
transmis
sion oil filter housing.
Magnetic Screen
1. Clean the area around cover (10).
2. Remove b
olts (11).
3. Remove cover (10).
4. Remove the magnetic screen from magnetic
screen housing (12).
5. Separate the magnets from the magnetic screen.
Wash the magnetic screen and the magnets in a
nonfla
mmable solvent.
Note: Do not rap the magnets on hard objects. The
magne
ts may be damaged. Replace any damaged
magnets.
6. Allo
w the cleaned parts to dry. Use compressed
air in order to speed the drying of the parts.
7. Clea
n the magnets with a towel or clean the
magnets with a stif f bristle brush.
8. Ins
tall the magnets into the magnetic screen.
9. Install the magnetic screen into magnetic screen
hou
sing (12).
10. Install the cover and the bolts.
11. Add transmission oil. Maintain the oil level
between the “FULL” mark and the “ADD” mark in
th
e sight gauge of the transmission oil reservoir.
12. Start the engine. Run the engine at low idle.