Specifications

168 SEBU7858-03
Maintenance Section
Transmission Oil Filter and Magnetic Screen - Replace/Clean
7. Clean the insid
e of the transmission oil filter
housing with a clean towel.
8. Insert a new fil
ter element into the transmission oil
filter housing.
9. Inspect the s
eal for the transmission oil filter
housing. Replace the seal if the seal is damaged.
10. Install the
cover on the transmission oil filter
housing. Install the bolts on the transmission oil
filter housing.
11. Clean the drain plug. Install the drain plug in the
transmission oil filter housing.
Magnetic Screen
g01124854
Illustration 236
The ma
gnetic screen is located below the
transmission oil filter at the rear of the transmission
case.
1. Clean the area around drain plug (6). Clean the
area around cover (5).
2. Remove the drain plug. Drain the oil into a suitable
container.
3. Remove bolts (4).
4. Rem
ove cover (5).
5. Remove the magnetic screen.
6. Separate the magnets from the magnetic screen.
W ash the magnetic screen and the magnets in a
no
nflammable solvent.
Note: Do not rap the magnets on hard objects. The
ma
gnets may be damaged. Replace any damaged
magnets.
7
.
A
llow the cleaned parts to dry. Use compressed
air in order to speed the drying of the parts.
8. Clean the magne
ts with a towel or clean the
magnets with a stif f bristle brush.
9. Install the ma
gnets into the magnetic screen.
10. Install the magnetic screen into the transmission
case.
11. Install the cover and the bolts.
12. Clean the drain plug. Install the drain plug.
13. Add transmi
ssion oil. Maintain the oil level
between the “FULL” mark and the “ADD”
mark in the sight gauge for the transmission.
Refer to Op
eration and Maintenance Manual,
“Transmission Oil Level - Check” for the proper
procedure.
14. Start the engine. Run the engine at low idle.
15. Check the
transmission oil filter for leaks. Check
the magnetic screen for leaks.
16. Check the
oil level of the transmission. Add oil, if
necessary.
17. Stop the
engine.