Specifications

ManualsBrandsCAT ManualsLawn Mower627G

SEBU7858-03 103

Maintenance Section

Auger Bearing Oil - Change

g00909637

Illustration 106

The air tank for the scraper is on the right rear side

of the scraper.

Open drain valve (2). Allow the moisture and the

sediment to drain into a suitable container. Close

valve (2).

i02457744

Auger Be

aring Oil - Change

SMCS Code: 6282-044-BD

S/N: DBZ1-Up

NOTICE

Care must be taken to ensure that ﬂuids are contained

during performance of inspection, maintenance, test-

ing, adjusting and repair of the product. Be prepared to

collect the ﬂuid with suitable containers before open-

ing any compartment or disassembling any compo-

nent containing ﬂuids.

Refer to Special Publication, NENG2500, “Caterpillar

Dealer Service Tool Catalog” for tools and supplies

suitable to collect and contain ﬂuids on Caterpillar

products.

Dispose of all ﬂuids according to local regulations and

mandates.

1. Park the machine on level ground. Run the engine

at low idle.

2. Move the transmission control to the NEUTRAL

position. Engage the parking brake.

3. Lower the bowl to the ground. Open the apron.

Lock the apron in the RAISED position. Refer to

Operation and Maintenance Manual, “Blocking the

Bowl and Apron” for further information.

4. Stop the engine.

g00943824

Illustration 107

Note: The bearing is located on the lower end of the

auger.

5. Clean the area around screws (1) and cover (2).

6. Remove screws (1) a nd cover (2).

g0094

3828

Illustration 108

7. Clean the area around oil level/ﬁll plug (3) and

vent plug (4).

8. Remove oil level/ﬁll plug (3) and vent plug (4).

9. Ins

ert a 1U-7683 Suction Gun through the

opening for the oil level/ﬁll plug. Suck the used oil

from the bearing housing.

Refer to Operation and Maintenance Manual,

“Lubricant Viscosities” for further information.

Refer to Operation and Maintenance Manual,

“Capacities (Reﬁll)” for further information.

10. Fill the bearing housing with oil until oil ﬂows out

of the opening for the oil level/ﬁll plug.

11. Clean the oil level/ﬁll plug. Install the oil level/ﬁll

plug.

12. Clean the vent plug. Install the vent plug.