Specifications

SEBU7858-03 165
Maintenance Section
Transmission Oil - Change
g00923132
Illustration 231
The transmission breather for the scraper is located
on the top of the transmission oil reservoir at the left
rear of the scraper.
Use the following procedure to clean each breather.
1. Clean the area around the breather.
2. Remove the breather.
3. Wash the breather in clean, nonflammable solvent.
4. Allow the breather to dry.
5. Install the breather.
i02557892
Transmission Oil - Chang e
SMCS Code: 3030-044
Hot oil and hot c omponents can cause personal
injury. Do not allow hot oil or hot components to
contact skin.
NOTICE
Care must be taken to ensure that fluids are contained
dur
ing performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
in
g any compartment or disassembling any compo-
nent containing fluids.
Re
fer to Special Publication, NENG2500, “Caterpillar
Dealer Service Tool Catalog” for tools and supplies
suitable to collect and contain fluids on Caterpillar
p
roducts.
Dispose of all fluids according to local regulations and
m
andates.
Procedure for the Tractor
g01279936
Illustrat
ion 232
(1) Differential dra in plug
(2) Transmission drain plug
Transmission drain plug (2) is located under the
tractor. Differential drain plug (1) is closer to the front
of the mac
hine.
Note: Operate the machine until the transmission
oil is wa
rm.
1. Park the machine on a level surface. Engage the
parking
brake.
2. Lower the bowl to the ground. Stop the engine.
3. Clean the area around drain plug (2).
4. Remove
drainplug(2).Draintheoilintoasuitable
container.
Note:
Clean the suction screen at this time. Refer to
Operation and Maintenance Manual, “Suction Screen
(Transmission Scavenge) - Clean” for the proper
proc
edure.
5. Clean drain plug (2). Install the drain plug.
g00923190
Illustration 233