Specifications

SEBU7858-03 157
Maintenance Section
Hydraulic System Oil Level - Check
i02503111
Hydraulic System Oil Level -
Check
SMCS Code: 5050-535-FLV
S/N: DBD1-Up
Note: Befor
e you check the hydraulic tank oil level,
the machine must meet the following conditions:
•
The machine
must be level.
•
The parking brake must be applied.
•
The hydraulic oil must be warm.
•
The engine
must be running at low idle.
•
The transmission control must be in NEUTRAL.
•
The cushion-hitch must be in the OFF position.
•
The eject
or must be moved forward.
•
Slight downward pressure must be applied on the
bowl.
g01124663
Illustration 214
The hydraulic tank is located in front of the right
tractor wheel. Hydraulic oil fillercap(2)islocatedon
top of the hydraulic tank.
1. Clean sight gauge (1) in order to view the hydraulic
tank oil level.
g01124666
Illustration 215
2. If necessary, add oil to the hydraulic tank.
Note: Clean hydraulic oil filler cap (2) before adding
oil to the hydraulic tank.
3. The hydraulic oil filler cap is a locking cap. If a
padlock is on the cap, remove the padlock. Raise
lever (3) in order to engage the lug.
4. Turn the hydraulic oil filler cap counterclockwise in
order to remove the cap. Slowly remove the cap in
order to relieve pressure in the hydraulic tank.
1. Add hydraulic oil until the oil level in the sight
gauge is at the “FULL” level.
2. Inspect the hydraulic oil filler cap for damage to
the seal. If the seal is damaged, replace the seal.
3. Install the hydraulic oil filler cap.
i034
29784
Hydraulic System O il Sam ple
-Obt
ain
SMCS Code: 5050-008; 7542-008
S/N: DBD1-Up
Not
e: Your machine may be equipped with a “Type 1”
location of the sampling valve or a “Type 2” location
of the sampling valve.