Specifications

142 SEBU7858-03
Maintenance Section
Engine Oil and Filter - Change
12. Clean the area a
round oil filler cap (5). Remove
the oil filler cap . Fill the crankcase with new oil.
See the following topics:
•
Operation and Maintenance Manual, “Lubricant
Viscosities”
•
Operation and Maintenance Manual, “Capacities
(Refill)”
•
Operation and Maintenance Manual, “Engine
Oil Level - Check”
13. Clean the oil filler cap and install the oil filler cap.
14. Start the e
ngine and allow the oil to warm. Check
the engine for leaks. Check the filter for leaks.
15. Run the eng
ine and check oil gauge (4) after the
engine has been running for ten minutes. Maintain
the oil between the marks on the “LOW IDLE” side
of the oil
gauge. If necessary, add oil.
16. Close the engine access door and stop the
engine.
i02345873
Engine Oil and Filter - Change
(Scraper Engine)
SMCS Code: 1318-510
S/N: DBZ1-Up
NOTICE
Care
must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
coll
ect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, “Caterpillar
Dealer Service Tool Catalog” for tools and supplies
sui
table to collect and contain fluids on Caterpillar
products.
Di
spose of all fluids according to local regulations and
mandates.
Hot oil and hot c omponents can cause personal
injury. Do not allow hot oil or hot components to
contact skin.
Note: API CH-4,
API CI-4, and API CI-4 P LUS oils
are acceptable in the C9 Acert Diesel Engine if
the requirements of Caterpillar's ECF-1 (Engine
Crankcase Flu
id specification - 1) are met. The oil
change interval should not exceed 250 hours.
g01122264
Illustration 186
The crankcase drain for the scraper engine is located
on the oil pan of the engine.
g01122257
Illustration 187
g
01122259
Illustration 188
The oil filter for the scraper is located on the right
side of the engine.