Specifications

140 SEBU7858-03
Maintenance Section
Engine Oil Sample - Obtain
The dipstick (4
) for the scraper engine is located on
the right side of the scraper.
1. Park the machi
ne on level ground. Lower the bowl
to the ground.
2. Remove the pa
dlock from the dipstick (if
equipped). Check the “ENGINE LOW IDLE”
side of the dipstick while the engine is running.
Maintain th
e oil level between the “ADD” mark and
the “FULL” mark.
Check the “E
NGINE STOPPED” side of the
dipstick while the engine is stopped. Maintain the
oil level between the “ADD” mark and the “FULL”
mark.
Note: When you operate the machine on severe
slopes, th
e oil level in the engine crankcase must be
at the “FULL” mark o n the “ENGINE LOW IDLE” side
of the dipstick.
3. Clean the area around the oil filler cap (3). Remove
the padlock from the oil filler cap (if equipped).
Remove th
eoilfiller cap. If necessary, add oil.
4. Clean the oil filler cap and install the oil filler cap.
5. Install both padlocks (if equipped).
i02224958
Engine O il Sam ple - O btain
SMCS Code: 1000-008; 7542-008
g01115066
Illustration 181
Engine oil sampling valve for the tractor
The sampling valve for the engine oil of the tractor
is located on the filter mounting base. The filter
mounting base is located on the right side of the
engine in the engine compartment.
g01122239
Illustration 182
Engine oil s ampling valv e for the scraper
The sampling valve for the engine oil of the scraper
is located on the filter mounting base. The filter
mounting base for the scraper is located on the left
side of the engine in the engine compartment.
Refer to Special Publication, SEBU6250, “S·O·S Oil
Analysis” for information that pertains to obtaining a
sample of the engine oil. Refer to Special Publication,
PEHP6001, “How To Take A Good Oil Sample” for
more information about obtaining a sample of the
engine oil.
i02324535
Engine Oil and Filter - Change
(Trac tor En gin e )
SMCS Code: 1318-510
S/N:
DBD1-Up
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, “Caterpillar
Tools and Shop Products Guide” for tools and supplies
suitable to collect and contain fluids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.