Specifications

SEBU7858-03 139
Maintenance Section
Engine Oil Level - Check
•
Operation and M
aintenance Manual, “Capacities
(Refill)”
•
Operation and
Maintenance Manual, “Engine
Oil Level - Check”
10. Remove the ho
se from the male coupler. Install
the dust cover.
11. Start the en
gine and allow the oil to warm. Check
the engine for leaks. Check the male fitting for
leaks. Check the filter for leaks. Shut off the
engine.
12. Remove the padlock from the oil gauge (if
equipped)
. Run the engine and check oil gauge (5)
after the engine has been running for ten minutes.
Maintain the oil between the marks on the “LOW
IDLE” side
of the oil gauge. If necessary, add oil.
13. Install the padlock (if equipped).
i02224857
Engine Oil Level - Check
SMCS Code: 1000-535-FLV
Hot oil and hot c omponents can cause personal
injury. Do not allow hot oil or hot components to
contact skin.
NOTICE
Do not
under fill or overfill engine crankcase with oil.
Either condition can cause engine damage.
Engine Oil Level (Tractor)
g01115060
Illustration 178
The dipstick (1) for the tractor engine is located on
the right side of the tractor.
1. Park the machin
e on level ground. Lower the bowl.
2. Open the engine access cover that is on the right
side of the mac
hine.
3. Check the “LOW IDLE” side of dipstick (1) while
the engine is
running. Maintain the oil level
between the “ADD” mark and the “FULL” mark.
Check the “E
NGINE STOPPED” side of dipstick
(1) while the engine is stopped. Maintain the oil
level between the “ADD” mark and the “FULL”
mark.
g01116258
Illustration 179
Note: When you operate the machine on severe
slopes, the oil level in the engine crankcase must be
at the “FULL” mark on the “ENGINE STOPPED” side
of the dipstick (1).
4. Clean the area around the oil filler cap (2).
Remove the oil filler cap. If necessary, add oil.
5. Clean the oil filler cap and install the oil fi ller cap.
6. Close the engine access cover.
Engine Oil Level (Scraper)
g
01122228
Illustration 180