Specifications

SEBU7858-03 109
Maintenance Section
Bail Bearings and Push Plate Spring - Lubricate
The backup alar
m should sound immediately. The
alarm alerts the personnel behind the machine
that the machine is backing up. The backup alarm
should contin
ue to sound until the transmission
control lever is moved to the NEUTRAL position
or to the FORWARD position.
i01779494
Bail Bearin gs and Push Plate
Spring - Lubricate
SMCS Code: 6262-086; 7115-086-BD
S/N: DBD1-
Up
g00909682
Illustration 118
One gr
ease fitting ( 1) is located on each side of the bail. G rease
fittin
g (2) is located on the spring for the push plate.
The grease fittings for the bearings of the bail and
the p
ush plate spring are located at the front of the
tractor.
1. Clea
n the grease fittings.
2. Remove the covers that are on the fittings.
3. Lubricate the three fittings.
4. Rep
lace the covers that are on the fittings.
i01851167
Battery - Clean/C heck
SMCS Code : 1401-070; 1401-535; 1402-070;
1402-535
1. Turn the engine start switch to the OFF positi on.
Turn all switches to the OFF position.
2. Turn the battery disconnect switch to the OFF
position. Remove the key.
3. At the battery d
isconnect switch, disconnect the
negative battery cable that is connected to the
frame.
Note: Do not allow the disconnected battery cable to
contact the disconnect switch.
4. Check the battery terminals for corrosion. If
corrosion is presen t, clean the battery terminals
withawireb
rush.
5. Coat the battery terminals with petroleum jelly, if
necessary.
6. Connect the negative battery cable at the battery
disconnec
tswitch.
7. Install the key for the battery disconnect switch.
Turn the ke
y to the ON position.
i00993589
Battery - Rec ycle
SMCS Code: 1401-561
Always recycle a battery. Never discard a battery.
Always return used batteries to one of the following
locations:
•
A battery supplier
•
An authorized battery collection facility
•
Recycling facility
i01851175
Batt
ery or Battery Cable -
Inspect/Replace
SMC
S Code: 1401-040; 1401-510; 1402-040;
1402-510
1. Tur
n the engine start switch to the OFF position.
Turn all switches to the OFF position.
2. Tu
rn the battery disconnect switch to the OFF
position. Remove the key.
3. At
the battery disconnect switch, disconnect the
negative battery cable that is connected to the
frame.
Note: Do not allow the disconnected battery cable to
contact the disconnect switch.
4. Disconnect the negative battery cable from the
terminals of the battery.