Installation Guide

INSTALLATION GUIDE

Toyota Tundra .L model (+)

TOOLS REQUIRED

• ¼” bit driver

• Protective eyewear

INSTALLATION TIPS

• Torque specs for M8 tamper-proof

screws: 68-135 inch lbs.

• Assistance is recommended to

hold the shield in place.

• Do not use impact tool or electric

drills.

Thank you for purchasing the best

Tundra converter theft deterrence

device on the market.

Please read the instructions below to

ensure the most accurate and secure

t for your Cat Shield. Professional

installation is recommended.

PARTS INCLUDED WITH YOUR CAT SHIELD

Nut plates

Tamper-proof

at head screws

(short)

x12

Tamper-proof

at head screws

(medium)

Tamper-proof

at head screws

(long)

M8 short & long

screws tamper-

proof key bit

M8 medium

screws tamper-

proof key bit

PAGE 1
INSTALLATION GUIDE Toyota Tundra 3.5L model (2022+) Thank you for purchasing the best Tundra converter theft deterrence device on the market. Please read the instructions below to ensure the most accurate and secure fit for your Cat Shield. Professional installation is recommended.
PAGE 2
STEP 1 C Install the two wings onto the shield. Using the 12 short tamper-proof screws, install the left and right side wings to the main shield. Refer to image A. A Side Wing Side Wing D Rear Shield B Used in Hybrid Model Holes Used on Rear Cross Member STEP 3 Install the front end of the shield. Locate the two threaded holes in the front cross member and use the two medium length tamper-proof screws to secure the shield to the vehicle. STEP 2 Install the rear end of the shield.