Installation Guide

ManualsBrandsCAT SHIELD ManualsOtherCAT SHIELD Catalytic Converter Shield Guard 2007-2021 Toyota Tundra 2WD

Toyota Tundra WD model (–)

Toyota Sequoia (–)

INSTALLATION GUIDE

TOOLS REQUIRED

• Rivet nut tool with

M6 mandrel/head

• ¼” bit driver

• 12mm opened wrench

• Protective eyewear

INSTALLATION TIPS

• Torque specs for M6 tamper-proof

screws are 37-72 inch lbs and

68-135 inch lbs for M8 tamper-

proof screws.

• Assistance is recommended to

hold the shield in place.

Thank you for purchasing the

best Tundra and Sequoia catalytic

converter theft deterrence device

on the market.

Please read the instructions below to

ensure the most accurate and secure

t for your Cat Shield. Professional

installation is recommended, and

knowledge of using rivet nuts plus a

rivet nut tool is necessary.

Check out www.catshield.com

for installation videos.

PARTS INCLUDED WITH YOUR CAT SHIELD

Tamper-proof

at head screws

(short)

Lock washers

¼” tamper-proof

key bit (M6

screws)

Rivet nuts

(includes 1 extra)

Fender washers

Nut plate

¼” tamper-proof

key bit (M8

screws)

Tamper-proof

button head

screws

Tamper-proof

at head screws

(long)

Nuts

Summary of content (3 pages)

PAGE 1
Toyota Tundra 4WD model (2007–2021) Toyota Sequoia (2008–2021) INSTALLATION GUIDE Thank you for purchasing the best Tundra and Sequoia catalytic converter theft deterrence device on the market. Please read the instructions below to ensure the most accurate and secure fit for your Cat Shield. Professional installation is recommended, and knowledge of using rivet nuts plus a rivet nut tool is necessary. Check out www.catshield.com for installation videos.
PAGE 2
STEP 1 Install rivet nuts (x2). Locate the two (2) pre-existing holes in the back side of the the transmission cross member. Use a rivet nut tool and install two (2) rivet nuts in the holes. The 4WD model will require the transfer case and transmission to be slightly lifted to install the rivet nut on the driver side hole. mounts by inserting the tamper-proof flat head screw (long) through the cross member and into the nut plate (see image D).
PAGE 3
E STEP 6 Tighten all remaining screws and nuts. Make sure the shield and bracket line up in their proper locations and use the security screw keys and M12 opened end wrench to completely tighten the shield to the vehicle. STEP 7 Apply Cat Shield sticker (optional). Place the sticker on the vehicle to warn thieves this vehicle is protected by Cat Shield! Congratulations! You are now #catshieldprotected. If you have any questions or feedback about our product, contact us at info@millercat.com.