Installation Guide

ManualsBrandsCAT SHIELD ManualsGenerationCAT SHIELD 2014-2022 Toyota 4Runner 5TH Generation

M6 Tamper-proof

screws (long)

INSTALLATION GUIDE

Toyota 4Runner 5

Generation

TOOLS REQUIRED

• ¼” bit driver

• 12mm socket

• Protective eyewear

INSTALLATION TIPS

• Torque specs for M6 tamper-

proof screws are 37-72 inch

lbs and 68-135 inch lbs for M8

tamper-proof screws.

• Assistance is recommended to

hold the shield in place.

• Some versions may come

with a different number of bits

depending on the screw heads.

Thank you for purchasing the

best 4Runner converter theft

deterrence device on the market.

Please read the instructions below to

ensure the most accurate and secure

t for your Cat Shield. Professional

installation is recommended.

NOTE: This shield is designed to

be installed only on 4Runners that

have cross bars or the threaded

holes where the cross bars would

be located.

PARTS INCLUDED WITH YOUR CAT SHIELD

Fender washers

M8 Tamper-

proof screws

Lock washers

(small)

¼” tamper-proof

key bit (M8

screws)

Fender washers

(heavy)

¼” tamper-proof

key bit (M6

screws)

M6 Tamper-proof

screws (short)

Summary of content (3 pages)

PAGE 1
INSTALLATION GUIDE Toyota 4Runner 5TH Generation Thank you for purchasing the best 4Runner converter theft deterrence device on the market. Please read the instructions below to ensure the most accurate and secure fit for your Cat Shield. Professional installation is recommended. NOTE: This shield is designed to be installed only on 4Runners that have cross bars or the threaded holes where the cross bars would be located.
PAGE 2
STEP 1 the rear) will prevent the removal of the bar while allowing Remove the two cross bars. Remove the four bolts holding the cross bar to be securely torqued. Refer to image C the cross bars by using a 12mm socket. Set the two cross to see where to add the tamper-proof screws. The order bars aside for later installation. Refer to image A. of the tamper-proof screw will be: M8 screw and fender washer (heavy).
PAGE 3
STEP 5 Tighten all screws and reinstall the cover assembly. Refer to image E for the fully installed shield. E STEP 6 Apply Cat Shield sticker (optional). Place the sticker on the vehicle to warn thieves this vehicle is protected by Cat Shield! Congratulations! You are now #catshieldprotected. If you have any questions or feedback about our product, contact us at info@millercat.com. Don’t forget to tag us with your latest install using @millercatcorp and #catshieldprotected.