Assembly Instruction Item# 600-4X Medium Pet Crate End Table
Page 2/6 A Parts List E D B C F (A) Top Panel 1 Pc. (B) Bottom Panel 1 Pc. (C) Left Panel 1 Pc. (D) Right Panel 1 Pc. (E) Back Panel 1 Pc. (F) Door 1 Pc.
Page 3/6 x2 RF50003 x4 RF10004 C Lef t Pa n els D Rig ht x2 Pa n els RF50003 x4 RF10004 x2 RF50003 x4 RF10004 E Ba ck Diagram 1. Pa n els Step 1. Attach 6 L-Bracket (RF50003) into the pre-drilled holes on the Left Panel (C), Right Panel (D) and Back Panel (E) using 12 screws (RF10004) as per Diag. 1.
Page 4/6 E RF10004 x2 Diagram 2. A Step 2. Attach Back Panel (D) into the Top Panel (A) by using 2 screws (RF10004) as per diagram 2. D E RF10004 x2 C E A D RF10004 x2 Diagram 3. A Step 3. Attach Left and Right Panel (C&D) into the pre drilled holes on the Top Panel (A) using 6 screws (RF10004) as per diagram 3.
Page 5/6 Loosen Tighten Tip: 1 - 4 is the adjustment point for the balance of Bottom Panel (B). RF10041 2 x6 1 3 B 4 E C D A Diagram 4. Step 4. Attach Bottom Panel (B) into the unit by using 6 screws (RF10041) as per diagram 4.
Page 6/6 Tip: Carefully hold the pins to prevent it from bouncing off A D F C B RF40002 Diagram 5. x2 RF40009 x2 RF44013 x2 Step 5. Assemble the Door (F); Place Spring (RF40002), Door Pin (RF40009) and Washer (RF44013) into pre-drilled holes on the Door (F) as per diagram. Align the pin on top of Door (F) to the hole underneath the Top Panel (A), then align the pin in bottom of Door (F) to Bottom Panel (B).
