User's Manual

Doc.# MAN-QPX0-FAET-02.00.0

Revision History

Version Date Editor Description

01.00.0 2008-08-05 Jackie Create

02.00.0 2010-03-26 Eaton

1. Added exterior and parts description of

QP2000 & QP3000.

2. Added QP2000 & QP3000 SAM card

installation procedures

3. QProx reader series’ external DC

adaptor supplies 12V/1A of power

through RS232 port.

4. Added pin assignment of internal pin

out 8 pins connector.

FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must

accept any interference received, including interference that may cause undesired operation. Note: The

manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to

this equipment. Such modifications could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radi-ate radio

frequency energy and, if not in-stalled and used in accordance with the in-structions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equip-ment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the fol-lowing measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equip-ment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the re-ceiver is connected.

—Consult the dealer or an experienced radio/ TV technician for help.