Technical data

50
Solution
6.1 If this message is displayed during heat up, it indicates a bad temperature sensor. 6.2 Heating elements are remaining on instead of cycling on and off. In both cases call for a technician. 7.1 Air jet is clogged. Clean air jet according to sec. 9.4. 7.2 Heating elements are remaining on instead of cycling on and off. Call for a technician. 7.3 Temperature sensor (PT100) is faulty or dirty. Call a technician. 8.1 Make sure the paper is mounted in the right way. Only one side of the paper is printable, (see sec. 5.2, Printer handling). 9.1 Make sure the paper is inserted in the printer, (see sec. 5.2, Printer handling). 9.2 Switch off the machine and switch it back on while pressing the feed button on the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem. 10.1 Make sure the ‘feed button’ on the printer is not stuck. 11.1 Make sure the door is tightened enough and the door gasket is sealing the Chamber. Replace the door gasket, (see sec. 9.5 Replacing the Door Gasket). 12.1 If you are running a ‘glassware’ program, this is normal. The slow exhaust will take from between 15 and 20 minutes, (see, Program 3 sec 4.3). 13.1 Clean strainer according to instructions, (see sec 9.8).
8. The printer prints, but nothing
is printed on the paper.
9. The printer does not print. 10. When the machine is
switched on, the printer gives
paper feeds all the time.
Problem
6. ‘High Temp’ is displayed. 7. ‘High Pres’ is displayed.
If equipped
with a
printer
11. The machine is leaking at the door. 12. When running a cycle, the exhaust stage
takes a very long time.
13. Water does not exit chamber due to
clogged outlet strainer.