Quick Installation Guide For INFINITY 401 Package Contents QIG x1 INFINITY401 x1 Power Adapter x1 (12V/2A ) RJ-45 Cable x1
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide Front Panel & LEDs There are Light-Emitting-Diodes (LEDs) located on the front panel to indicate the status information of cable modem. NAME COLOR MODE STATUS TEL2/TEL1 Green On Off Blinking WPS Blue Blinking On Off WPS in paring WPS enabled WPS disabled WLAN 5GHz Green On Off Blinking Wi-Fi enable Wi-Fi disable Data in traffic WLAN 2.
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide Rear Panel and Hardware Connection The following describes the proper steps for connecting your cable modem. Please be sure to follow the steps in the sequence outlined below. Failure to do so could result in improper operation or failure of your cable modem.
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide Accessing the Web Management For easy-changing the default settings, a Web-based GUI is built-in for your access. Use the following procedures to login to your INFINITY 401 . 1. Open your web browser. 2. Type the default IP address of the INFINITY 401 (http://192.168.20.1) and press Enter. 3. The Log In page appears. Type the user name (admin) and your password (password) in the respective fields.
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide Check your INFINITY 401 Access Information There is a label pasted to the bottom of INFINITY 401 case. In that label, you can obtain following information. Please note, following label is just an example, each INFINITY 401 has their own label and setting value. Please follow your label information to access and configure INFINITY 401. In normal case, you don’t need to change anything, all setting have been set and work properly.
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide Note to CATV Sysrem Installer "The EUT must be bonding the screen of the coaxial cable to the earth at the building entrance per ANSI/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.
INFINITY 401 DOCSIS/EURODOCSIS 3.0 Cable Modem Quick Installation Guide FCC Statement This device complies with Class B Part 15 of the FCC Rules. The device generates, uses and can radiate radio frequency energy and, if not installed and used as instructed, may cause harmful interference to radio communication. Only Coaxial cables are to be used with this device in order to ensure compliance with FCC emissions limits. Accessories connected to this device by the user must comply with FCC Class B limits.
