User Manual

PPTP PassThrough PPTP (Point to Point Tunneling Protocol) is the method
used to enable VPN* sessions to a Windows NT4.0, 2000 server. To allow
tunnels to pass through the CBW500. The default setting is enable.
*VPN (Virtual Private Networking) is a security measure that basically creates
a secure connection between two remote locations.
Remote Config Management This feature allows you to manage your
Gateway from a remote location, via the Internet. To enable this feature, tick
Enable, and use the specified port (default is 8080) on your PC to remotely
manage the CBW500. You must also change the CBW500's default password
if you haven’t already. A unique password will increase security.
To remotely manage the Router, enter http://xxx.xxx.xxx.xxx:8080 (the x’s
represent the CBW500's Internet IP address, and 8080 represents the
specified port) in your web browser’s Address field. You will be asked for the
CBW500’s password. After successfully entering the password, you will be
able to access the Gateway’s web-based utility.
Multicast Enable IP Multicasting occurs when a single data transmission is
sent to multiple recipients at the same time. With Multicast feature enable, the
CBW500 allows IP multicast packets to be forwarded to the appropriate
computers.
11