User's Manual


CastleNetBTC08R800UserGuide


CastleNetTechnologyInc.
Copyright© 2011 AllRightsReserved. 3 of 6


ThisdeviceisintendedonlyforOEMintegratorsunderthefollowingconditions:

Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaandusers,and
Thetransmittermodulemaynotbeco‐locatedwithanyothertransmitterorantenna.

As long as 2 conditions above are
met, further transmitter test will  not be required. However, the OEM
integrator is still responsible for testing their end‐product for any additional compliance requirements
requiredwiththismoduleinstalled

IMPORTANT NOTE: In the event that these conditions can not be  met (for example certain laptop
configurationsor co‐locati on  with
 anothertransmitter),then the FCCauthorizationisno longerconsidered
validandtheFCCIDcannotbeusedonthefinalproduct.Inthesecircumstances,theOEMintegratorwillbe
responsible for re‐evaluating the end product (including the transmitter) and obtaining a sepa rate FCC
authorization.

EndProductLabeling
Thistransmittermoduleisauthorizedonlyforuseindevicewheretheantennamaybeinstalledsuchthat20
cm maybe maintained  between the antennaand users. The final end product must be labeledin a visible
areawiththefollowing:“ContainsFCCID:RK9‐BTC08R800BLE”.Thegrantee'sFCCID
canbeusedonlywhen
allFCCcompliancerequirementsaremet.

ManualInformationTotheEndUser
TheOEMintegratorhastobeaware notto provideinformation totheenduser regardinghowtoinstallor
removethisRFmoduleintheuser’smanualoftheendproductwhich
integratesthismodule.
Theendusermanualshallincludeallrequiredregulatoryinformation/warningasshowinthismanual.
