Manual

5.12.1 TO RESET THE ROUTER FEED RATE:
1. Locate the Feed Rate knob on the left of the case and fully loosen the Jamb Nut. See
Fig 14.
FASTER
Knob and Ja
mb Nut
Router Feed Rate
SLOWER
Fig 14
2. Rotate the Feed Rate knob fully clockwise until it stops.
3. Rotate the Feed Rate knob 2 full revolutions counter-clockwise.
4. This setting is typical for hard woods.
5. Adjust the Feed Rate to your material by ½ or ¼ turn at a time to obtain a clean, smooth
pocket.
6. Counter-clockwise increases the Router Feed Rate, Clockwise decreases the Router
Feed Rate.
7. Tighten the Jamb Nut after adjustments are finalized.
Note: If the Router comes up with the Feed rate knob turned fully clockwise, the Feed rate
valve should be replaced.
Castle Inc TSM-21 Diagnostic Manual v2 Page 32 of 63