User Manual

CASTLE,INC TSM‐11OWNERSMANUALV1.4 Page19of22
4. Re-install the router in the yellow carriage, carefully noting the orientation depicted
below. With the motor firmly engaged against the
carriage, tighten the locknuts with a 7/16” wrench
and the bar knob alternating between both to
ensure even tension on the U-bolt.
6.2 Pilot Bit Replacement
1. Unplug the TSM-11 from the electrical outlet.
2. Remove the cap screw which holds the drill in place, and pull the drill out of the machine.
3. Remove the dull bit using the wrench provided. It may be necessary to lightly tap the
collet to loosen the bit. Insert the replacement drill bit
until the tapered portion of the shank is approximately
flush with the collet opening. Secure the bit.
Fig 32
Fig 33
Fig 34