Specifications

Castle Care-Tech Ltd. Engineering
Page 18 - 8 Chapter 18
NOTES: If zone is programmed
as ‘isolated’ then monitoring will
be SOLELY at the Door Station.
If the zone is to be monitored
by the alarm system ONLY, it
should be wired direct to the
system, NOT via the Door
Station.
H: SYSTEM LOGS
The system will log in the
ACCESS log, in the form:
15/09 14:15:24
Tag at Reader
Press C
John Smith
User 004
Press C
Device 07
Despatch Door
Press C
15/09 14:23:12
Tag at Reader
etc.
J: PROGRAMMING
TAGS
Tags are programmed through
the normal ‘Programme Codes’
routine in MANAGER menu.
Note relevant programming
options:
User Set Options
None [3]
Option ‘ None [3] ‘ identifies that tag
will NOT also set/unset the system
If alternative options [1] or [2] are
selected, tag can also be used (on
suitable Keypads/Set-Unset Tag
Readers) to control alarm system.
Reader [4]
Reader 4
Permits selection of which Access
Readers the tag will be valid at.
Bottom line of display will show
reader identification name which
has been programmed. Defaults to
lowest number reader, change as
required, then press YES. Figure in
brackets should be changed to
select an alternative or additional
reader, as required. Total list
allocated will scroll. Press YES again
with the same reader showing to
delete the reader.
Press NO on completion of
selection, to move to next option.
K: Access Control
Facility and DD243
Certain unsetting options
compliant with DD243:2002 may
be set up in conjunction with
the access control system.
Unlocking the initial entry door
unsets the system: use relay to
trigger zone programmed as
"unset."
Unlocking the initial entry door
disables confirmation: use relay
to trip zone programmed as
"FX" with "Disable Confirmation
on entry" option selected in
Alarm Response menu.