Quick Start Guide

© 2013 Castle Creations, Inc. P/N: 095-0223-00 Revision Date - 03/2013 PAGE 2 of 2
TONE MEANING
•
-
Low voltage cutoff
•
-
•
Over temperature
•
--
Excessive load
••
Start fail
••
-
Radio glitch
•••
Motor anomaly
-
•
Over-current
-
••
Auxiliary Wire Radio Glitch
PHOENIX EDGE ERROR CODES
OPTION DEFAULT SETTING
Auto-LiPo Volts/Cell 3.2 Volts/Cell
BEC Voltage 5.0V
Brake Delay 0.6 sec (Delayed)
Brake Ramp Immediate
Brake Strength Disabled
Current Cutoff Type Soft Cutoff
Current Limiting Normal
Cutoff Voltage Auto-LiPo
Direction Forward
Motor Start Power Medium 59
Motor Timing Normal 5
PWM Rate 12 Khz
Throttle Type Auto-Calibrate Endpoints
Vehicle Type Airplane
Voltage Cutoff Type Soft Cutoff
Auxiliary Wire Disabled
Link Live Disabled
Castle continually updates the firmware for this controller. Please use your Castle Link USB adapter, available directly from Castle
using the coupon included in the original product packaging, and free Castle Link software (available at castlecreations.com/
downloads) to install the most current firmware before operating this controller.
CLEARING THE DATA LOG
Power your controller up with your TX and RX on and set to full throttle. The controller will chime the normal power up chimes.
Leave your TX at full throttle for 6 seconds after power up. The controller will emit a short tone after 1 second and then a long
tone 5 seconds later. The controller will then erase the data log. You must then move the throttle stick to lowest power to arm the
controller.
DEFAULT SETTINGS