Castle X Series Drivers Ed Guide

27 28
FIELD LINK
™
PROGRAMMING CARD
You cn use  Field Link progrmming crd to esily chnge mny settings t the field without
your PC, or it will function s  Cstle Link dpter when you do hve  PC vilble. For more
informtion visit www.cstlecretions.com/fieldlink.
TRANSMITTER PROGRAMMING
Trnsmitter progrmming is very esy; simply nswer YES or O to  list of options. These re
grouped into five settings nd ech setting hs severl possible options. You cn only ccept
one option per setting. By nswering YES to n option you will jump to the next setting. If you
nswer O to n option you will move to the next option within tht setting.
At ech option, you cn ccept it by going to full throttle on your trnsmitter, or you cn reject
the option by going to full brke. In progrmming terms, full throttle is ‘YES’ nd full brke
is ‘O.’ The ESC will indicte tht it hs ccepted your selection by producing  continuous
“skipping” tone. hen you her this tone, llow the trigger to go bck to the neutrl position to
dvnce to the next setting or option depending on your selection.
How To Get Into Programming Mode:
. Turn your trnsmitter on.
. Plug the bttery into the ESC with its switch off. If your ESC does not hve  switch, hold full
throttle on your trnsmitter before plugging in the bttery.
. Hold full throttle on your trnsmitter nd turn the ESC switch on.
. The ESC will go through its boot-up sequence nd blink the green LED. If the ESC’s voltge
cutoff is set to Auto-LiPo (the defult setting), then the ESC will emit  sequence of beeps
indicting the number of bttery cells. If the number of beeps does OT mtch the number
of cells, disconnect the bttery nd confirm tht it is fully chrged.
. There will be  sequence of four “rings” nd the red LED will blink.