Castle Mamba Monster 2 Drivers Ed Guide

Option 2: Medium
Medium acceleration limiting. Good for 2WD vehicles on soft dirt, and 4WD vehicles on hard dirt.
Option 3: Low
Light acceleration limiting. Good for 4WD vehicles on soft dirt.
Option 4: Lowest
Very light acceleration limiting. Good for most situations including 4WD vehicles on dirt and asphalt, and 2WD vehicles on asphalt.
Option 5: Disabled (Default)
Acceleration is only limited by battery ability. This setting is good for 4WD sedans on carpet, high traction drag racing, or bashing
where unlimited wheelie power is desired.
5. Drag Brake
Sets the amount of drag brake applied at neutral throttle to simulate the slight braking eect of a neutral brushed motor while
coasting.
Option 1: Drag Brake OFF (Default)
Vehicle will coast with almost no resistance from the motor at neutral throttle.
Option 2: Drag Brake 10%
Low amount of braking eect from the motor at neutral throttle.
Option 3: Drag Brake 20%
More braking eect from the motor at neutral throttle.
Option 4: Drag Brake 30%
Fairly high braking eect from the motor at neutral throttle.
Option 5: Drag Brake 40%
High braking eect from the motor at neutral throttle.
6. Dead Band
You may adjust the neutral throttle “width” of the controller with this setting.Smaller values make the controller enter forward
or brake/reverse with a smaller movement of your throttle trigger for finer control. Be careful, some transmitters oer better
resolution than others. If your ESC will not respond to “Neutral” throttle, make this setting larger.
Option 1: Large - 0.1500 ms
Option 2: Normal - 0.1000 ms (Default)
Option 3: Small - 0.0750 ms
Option 4: Very Small - 0.0500 ms
Option 5: Smallest - 0.0250 ms
7. Cuto Voltage
Sets the voltage at which the ESC lowers or removes power to the motor in order to either keep the battery at a safe minimum
voltage (Lithium Polymer cells) or the radio system working reliably (NiCad/NiMH cells).
Option 1: None
Does not cut o or limit the motor due to low voltage. Do not use with any Lithium packs!
Applications: Any racing or bashing situation with 6-8 cell NiCad or NiMH packs.
Use this setting ONLY with NiCad or NiMH packs. With continued driving, the radio system may eventually cease to
deliver pulses to the servo and ESC, and the vehicle will not be under control. You will irreversibly damage Lithium
Polymer packs with this setting!
Option 2: Auto-Lipo (Default)
This setting automatically detects the number of LiPo cells you have plugged in. It will automatically set the cut-o to 3.2 volts
per cell. It will beep the number of cells in your LiPo pack between the initialization tones and the arming tones on initial power
up of the controller.