Installation Guide

1
SAFETY
Before using the product, please read the following safety instructions carefully. Pay attention
to the following safety warnings.
We will not be responsible for any loss due to violation of either requirement below.
■
■ Qualification of installation person: The product should be installed by a
specially trained qualified plumber.
Before installing the product, please read the safety instructions right below
and those in other parts of this manual. Please install the product as instructed
in this manual. We will not be responsible for any adverse consequence due to
a change of the installation method.
SYMBOLS DESCRIPTION
Symbol Description Symbol Description
Kind reminder
Inspect visually
Inspect tightness
Caution！A low risk possibly
causing a light injury.
CAUTION!
Please avoid faults or damage of the product due to misoperation.
■ Do not use industrial water, circulating water, sea water or waste water as the water
source of the product. Please use a water source meeting the hygiene requirements for
domestic drinking water.
■ Do not bend, squeeze or wind the water supply pipe excessively.
■ Do not use benzene, paint thinner, cleaning powder or nylon brush but a thinned neutral
detergent to clean the product.
■ Do not use an old hose repeatedly. Please use the new hose provided with the product.
■ Do not strike the ceramic violently.
■ Do not put the product upside down.
■ When installing the product, please abide by all the local regulations on water supply and
drainage, and buildings to avoid safety hazards.
■ When using the product, make sure the water supply pressure and the water supply flow
are 0.1MPa to 0.86MPa (15PSI to 125PSI) and equal to or more than 9L/min(2.4gal/min),
respectively, to ensure thorough flushing.
■ Make sure that the water temperature is 4°C to 35°C (39.2°F to 95°F) and that the
bathroom temperature is above 4°C (39.2°F).
■ Before installation, water-proof treatment should be done for the bathroom’s floor and walls.
■ To avoid product surface scratches, please remove the electrostatic film on the product
after its installation.