Installation Guide

The filter needs to be cleaned at regular intervals. If the product
fails in water supply, has a water supply pressure smaller than
ordinary time or cannot work normally, please clean the filter first.
In cleaning, make sure the water supply switch is off; after
cleaning, mount the filter back and inspect and make sure
there’s no water leakage.
Filter
WINTERIZATION
When in use, make sure the indoor temperature is not below 4°C (39.2°F). When the
indoor temperature is below 4
°C (39.2°F), stop using the product and operate as below.
- Turn off the angle valve to stop water supply. After that, drain the water in the tank
to flush the product once.
SURFACE CLEANING
Use a smooth sponge or a piece of soft cloth dipped with a proper amount of room
temperature water or neutral detergent and then wrung out to wipe the product surface.
When cleaning any other part of the product, lift the top cover and the seat. Do not lay
down the to cover or the seat until the detergent in the product has been completely
flushed away, otherwise the evaporated detergent may corrode the product surface.
NOZZLE CLEANING
FILTER CLEANING
CLEAN & MAINTENANCE
2
11
If the product is maintained before drainage, the product may damage and leak.
If the product is moved from a cold place to a warm place, the water in it will
condensate. In this case, make the product stand for a couple of hours before use.
Pull out the jet pipe gently and pull it for at least 5 times. Hold the
jet pipe gently and wipe it and the nozzle with soft cloth, sponge or
small brush with some neutral detergent.