Specification

Issue
Heated Seat
Seat temperature is
not warm enough
during usage.
Seat temperature is
too hot
Is seat temperature set to“off” or
on the lowest setting?
Is seat temperature set on the
highest setting?
Reset the seat temperature to a higher
setting.
Reset the seat temperature to a lower
setting.
Long press the “Night Light” button
to turn on the light.
Nozzle will move back automatically
after 2mins from starting nozzle
self-cleaning mode.
Electro conductive material such as
water drops or wet paper sticks to
seat sensor and activate it,toilet is
not in off seat status.
Remove conductive media from the
seat.
Turn on water supply and power
supply recovery.
This is normal phenomenon.
Night light is set on “off” status.
Nozzle moves
back automatically
Nozzle does not
extend after long
pressing the“nozzle
clean” button.
Press the flush button
of remote control, the
product can't flush
automatically.
Drying temperature is
not warm enough.
Drying stops suddenly.
Drying function does
not work.
“ ”flashes once.
“ ”flashes twice at
once.
“ ”flashes three
times at once.
“ ”flashes four
times at once.
“ ”flashes.
Turn on the water and power on.
Please cut the power off, stop using
the product, and contact the manu-
facturer for more assistance .
Flow failure.
The outlet water temperature is too
high.
The inlet water temperature is too
high.
Water-related sensor failure.
The seat heating function failure.
Is the seat sensor being contacted?
There is noise during
flushing.
Is the water supply and power are
cut off or not?
Is drying temperature set to “off”
or on the lowest setting?
Reset the drying temperature on a
higher setting.
Sit on the seat sensor again and
press the drying button.
Did you select any cleansing
function?
Turn off the cleansing functions and
press the drying button.
If the user leaves the seat suddenly,
the sensor may not be able to find
the correct position of user.
Sit on the seat sensor again and
press drying button.
No Water supply or the water
pressure is very low.
This is normal phenomenon.
Clean the filter screen
Is the filter screen dirty?
Night light
function
Nozzle
cleansing
Drying
Indicator light
icon( / )
light flashes.
Flush function
Night Light Off
Night Light On
Night light is set on “on” status.
Long press the “Night Light” button
to turn off the light.
Cause
Solution
21
Troubleshooting
1606108679-001 1.0