Specification

15
Remote control instructions
● Rear cleansing/Front cleansing
When sitting, press button or button, enter the rear cleansing or front cleansing mode, press the button again to enter the
oscillated cleansing mode. The cleansing cycle which stops automatically after 3 minutes; or press button to stop the cleansing
function.
● ECO function
Long press button, turn on/off ECO function, when ECO function is on, the seat temp. will decrease slowly after leaving the
seat then keep at 82.4℉±5.4℉.
● Warm air dryer
When sitting on seat, press to activate drying function. It will stop when (1) you press button (2) working ≥ 5min (3)stops
at any time when users leaves the seat.
● User profile
After User 1 setting desired functions (Water temperature, drying temperature, water pressure, position), press button of
remote control for 3 seconds until the 5 indicator lights of remote control flash 3 times. The desired functions will be saved as user1.
The saved setting will be invoked when user press button on remote control. And the 5 indicator lights of remote control flash
1 times.
After User 2 setting desired functions (Water temperature, drying temperature, water pressure, position), press button on
remote control for 3seconds until the 5 indicator lights of remote control flash 3 times. The desired functions will be saved as user2.
The saved setting will be invoked when user press button on remote control. And the 5 indicator lights of remote control flash 1
times.
● Foot sensor mode
In off seat status, foot detection mode will achieve following function:
1. When lid & seat are closed, foot step in detection area to trigger lid opening.
2. When lid is opened, seat is closed, foot step in detection area to trigger seat opening.
3. When lid and seat are opened, foot step in detection area to trigger lid and seat closing and flushing.
Using Instruction:
1. Foot sensor flush works only in off seat status. 2.Enter the sensing area (from ceramic bottom to indicator's
illumination range) and stay about 0.5s to active the flush funtion.
Warm tips:
The sensor is optical device, which is highly sensitive, may have following issues.
1.Stains, water drops, or fog on sensor surface might cause sensing failure. Please wipe up in time.
2.Direct sunshine, bathroom heater lamp might cause sensing failure.
3.Mopping and other moving objects in front of sensor might cause sensing failure.
4.Shower keep spraying the sensor might have the probability of wrong trigger.
5.The foot sense breathing light flashes, which is convenient for the user to identify the foot sense position, and is not an
abnormal fault.
All cycle times may vary
Foot sensor
function
Induction area
Operation