Specification

12
850mm/33.5in
74mm
Installation
4.Tips for comfortable use
Glass cement
Outside the ceramic side
One side of the ceramic
Spots are easily found at the lower part of the
product after long time of water or urine penetration.
To avoid this, silicone is recommended to paste
around the lower part to seal the tiny gap between
the lower part and the ground.
Wipe clean the walls
Tear the paper of double sided tape
on the remote control holder
Press for a moment to ensure the double
sided tape sticks with the tiles tight
Insert the remote
control into holder
Drill two holes with a diameter of 4.5mm
in the wall according to the position of holes
on the remote control holder
Secure the remote control holder
with expansion screws
※Used up batteries should be thrown into
corresponding type of garbage cans
Recommended
installation position
of remote control
Install the remote
control batteries
5.Install the Remote Control
Installation Method 1:
Installation Method 2:
3.Install the Water Supply Hose
As shown in the figure, install water supply line to angle stop.
1) If the water inlet pressure is greater than 30psi, please
install the flow limiting plate in the angle stop;
2) Only use the accessory parts that are shipped with the
product for installation;
3) After installation,check water seal and turn on the power
supply. Water leakage shall be avoided.
E-bidet
braided hose
Water Supply Line
Large end facing
ball valve
A
A
B